JTAG/Boundary Scan tests

日期:2021-07-25 20:41
瀏覽次數:1902
摘要: JTAG/Boundary ScanJTAG(Joint Test Action Group)is an international standard Test protocol (IEEE 1149.1 compatible), mainly used for chip internal testing. Now the most advanced devices support JTAG protocol, such as DSP, FPGA devices, etc. 1,Boundary Scan a) BSDL validation b) Test program debugging c) Hardware debugging d) Testability optimization e) Fault coverage improvement 2,Structural test a) infra

                                                                             JTAG/Boundary Scan
JTAG(Joint Test Action Group)is an international standard Test protocol (IEEE 1149.1 compatible), mainly used for chip internal testing. Now the most advanced devices support JTAG protocol, such as DSP, FPGA devices, etc.

1,Boundary Scan
   a) BSDL validation
   b) Test program debugging
   c) Hardware debugging
   d) Testability optimization
   e) Fault coverage improvement

2,Structural test
   a) infrastructure test  b) connection test
  c) i/o connection test
  d) boundary scan/flying probe test
  e) RAM access
  f) logic cluster test
  g) components i/o test
  h) Analog I/o test
  i) currentless open/short test
  k) built-in self-test
  l) FPGA-assisted RAM access test
  m) FPGA-assisted bit error rate test(BERT)
  n) Universal frequency measurement

3,functional/emulation tests

    a) internal chip test
    b) cluster testopenshort.jpg
    c) board-i/o-test
    d) Core-assisted RAM access test
    e) Core-assisted system bus test
    f)  Core-assisted i/o test

4,programming of components
  a) PLD/FPGA programming
  b) Boundary Scan flash programming
  c) Micro contraller programming
  d) C0re-assisted flash programming
  e) FPGA-assisted flash programming

 

粵公網安備 44030602001522號

日本一级婬片A片在线观看视频,91精品国自产拍天天拍,亚洲中文字幕无码一区在线,美女胸18下看禁止免费视频